Menu
Cart 0

High Pressure Abrasive Waterjet Cutting Onshore & Offshore

Using low volume intensifier pumps, which use between 2.2 and 7.6 liters/min, and a minimal amount of abrasive (between 200 to 500 grams/min). By doing so the residual material and water used is kept to a minimal amount. 

Many hours of engineering has lead to a fitting solution to reduce the damage behind the waterjet to only 50 cm. Thus we are able to cut a 16”pipe spool from the outside in, without damaging the opposite side of the pipe spool. This technique can be applied on any kind of piping, vessel or tank, both onshore & offshore. 

The water jet cutting system is air powered, except for one electrical part which comes with an ATEX certificate. As a result we can safely work in a “live” plant, meaning that there will be no impact on revenues or production loss during our activities.

To ensure safety, we keep to our “hands-off-policy”; All our equipment can be operated from a distance, so our operator will always be out of harm’s way. 

Our product comes with 2 specialists whom have all the training required to work and travel offshore. All our specialist are also trained in Torque & Tensioning and are qualified as Rigger Stage 3, therefore, we can supply you with the complete skillset to get any job done.